Modifying a TD 200 Configuration
E.1
Types of TD 200 Configurations
If you have an existing TD 200 configuration, the initial TD 200 Wizard screen
offers you an opportunity to modify it (Figure E-1).
TD 200 Configuration Created using STEP 7–Micro/Win Version 3.1
If you are using STEP 7–Micro/WIN version 3.1 (or greater) and the existing
TD 200 configuration was created using the 3.1 version, you can use the TD 200
Wizard to change the configuration. Refer to Section 2.1.
Other Configurations
Use the procedures in Section E.2 and Section E.3 if:
You are using an earlier version of STEP 7–Micro/Win (prior to version 3.1).
You have a TD 200 configuration that was created with an earlier version of
STEP 7–Micro/Win (prior to version 3.1).
You want to update the TD 200 configuration to use an alternate character set.
Use the procedure in Section E.3 if:
You are using STEP 7–Micro/Win version 3.1 (or greater).
You have a TD 200 configuration that was created with an earlier version of
STEP 7–Micro/Win (prior to 3.1).
You want to create an alternate character set.
STEP 7-Micro/WIN - c:\microwin\project1.prj
File Edit View PLC Debug Tools Window Help
TD 200 Configuration Wizard
TD200
Figure E-1 TD 200 Wizard Detecting an Existing Configuration
E-2
Tools
Instruction Wizard..
TD 200 Wizard...
Customize ...
Options...
This wizard helps you configure TD 200 messages quickly and easily.
When completed, the wizard generates the supporting data block code.
Existing TD 200 Configuration blocks have been found. Would you like to
edit one of these configurations, or create a new block?
Blocks to Edit
Block at VB0
To begin configuring TD 200 messages, click Next.
A
A
Z
Z
< Prev
Next >
1, 1
SIMATIC TD 200 Operator Interface
C79000-G7076-C272-01
Cancel