Charging The Batteries - Datalogic LYNX BT 432 Quick Reference Manual

DATALOGIC
Linear barcode
Relative Size and Location of Aiming System Pattern
The field of view indicated by the aiming system will be smaller when the
Lynx™ BT is closer to the code and larger when it is farther from the code.
Symbologies with smaller bars or elements (mil size) should be read closer to
the unit. Symbologies with larger bars or elements (mil size) should be read
farther from the unit.
Successful reading is signaled by an audible tone plus a good-read green led.
If reading codes positioned on reflective surfaces, it may be
necessary to tilt the reader with respect to the code and/or set
the Camera Control parameters. For configuring the Camera
Control parameters refer to the Lynx™ BT Reference Manual
available on the CD-ROM.
NOTE

CHARGING THE BATTERIES

By placing the reader into the C-1000 battery charger or the OM-1000 BT cradle
it is possible to charge the Lynx™ BT batteries. Make sure the charging LED
goes on.
The LEDs positioned on the battery charger signal the charge status, as
described in the following table:
LED
Charging Red On = the battery charge is in progress.
Batt Full Green On = the battery is completely charged.
2
2D Matrix symbol
STATUS