Connecting Power To The Chassis; Connecting The Ac Power Supply - Cisco 8540 - Catalyst Campus Switch Router Modular Expansion Base Installation Manual

Connecting Power to the Chassis

Push the power supply into the power supply bay until the faceplate is flush with
Step 2
the cover.
Note
Tighten the captive installation screw by turning it clockwise.
Step 3
For power supply replacement information, see the "Replacing Power Supplies"
section on page 3-2.
Connecting Power to the Chassis
This section describes the procedures for connecting AC and DC power to the
chassis. This section contains the following topics:
Install proper grounding to avoid damage from lightning and
Note
power surges.

Connecting the AC Power Supply

To connect power to an AC power supply, follow these steps:
Step 1 Plug a power cord into the power cord connection of one AC power supply. (See
Figure 2-5.)
Catalyst 8540 Chassis Installation Guide
2-8
In a nonredundant configuration, install the power supply in
the left power supply bay.
• Connecting the AC Power Supply
Connecting the DC Power Supply
•
Chapter 2 Installing the Chassis
78-6134-03