Front Chassis Mount, External Scsi Devices - Motorola MVME712-10 User Manual

Front Chassis Mount, External SCSI Devices

To mount the MVME712-10 in the front of the chassis with external SCSI
devices, proceed as follows and see Figure 2-5.
1. Connect the furnished 100-conductor I/O cable to connector J9 on the
MVME712-10.
2. Install the MVME712-10 in a slot to the right of the MVME166 and tighten
the screws.
3. Connect the I/O cable to connector J9 on the MVME166.
4. Connect the furnished P cable from connector J8 on the MVME166 to the
external SCSI peripheral device.
C
SCSI terminators must be installed on the devices that are
aution
physically located at each end of the SCSI cable, and must
not be on other devices on the cable. Refer to the SCSI
specification for detailed instructions.
5. Install the cover that you previously removed, making sure that it does not
pinch any cables.
6. Connect the power cable to the AC power source and turn the unit on.
MVME712-10/D1
Installation Instructions
2-9
2