Rear Chassis Mount, Internal Scsi Devices - Motorola MVME712-10 User Manual

Rear Chassis Mount, Internal SCSI Devices

To mount the MVME712-10 at the rear of the chassis with internal SCSI
devices, proceed as follows and see Figure 2-7.
1. Insert the MVME712-10 module into the selected slot at the rear of the
chassis and tighten the attaching screws.
2. Connect the furnished P cable from connector J6 on the MVME712-10 to
connector J8 on the front of the MVME166. A longer cable may be needed
for some chassis conÞgurations.
3. If the P cable at J6 on the MVME712-10 covers connector J5, connect a user-
supplied cable with compatible pinouts from connector J7 on the
MVME712-10 to the internal SCSI device. If connector J7 is covered,
connect the cable to J5.
C
J5 and J7 are functionally the same. Do NOT use both at the
aution
same time, because to do so would create a SCSI stub greater
than .1 meter.
C SCSI terminators must be installed on the devices that are
aution
physically located at each end of the SCSI cable, and must
not be on other devices on the cable. Refer to the SCSI
specification for detailed instructions.
4. Connect the furnished 100-conductor I/O cable between connector J9 on
the MVME712-10 and I/O connector J9 on the MVME166. A longer cable
may be needed for some chassis conÞgurations.
5. Install the cover that you previously removed, making sure that it does not
pinch any cables.
6. Connect the power cable to the AC power source and turn the unit on.
MVME712-10/D1
Installation Instructions
2-13
2