Table of Contents
Advertisement
C
harging mode
Vol.Compen.
SOC
Factory reset
The default parameter values of solar charge controller could be restored via the Factory
reset page, which means the "Control parameter", "Load setting", "Charge mode" and
"Device password" of the devices could be restored to the factory defaults (the factory
default password of the devices is "000000").
Factory Reset
Yes
Failure information
The current failure information of the solar charge controller could be checked via
the Failure information page (a maximum of 15 failure messages could be displayed);
when the failures of solar charge controller are eliminated, the corresponding failure
information will also be automatically eliminated.
Failure Info.
1. Over voltage
2. Over load
3. Short circuit
Meter parameter
The meter model, software and hardware version, and SN NO.could be checked via
Meter parameter page. And the three parameters (Switch pages, Backlight, Audible
alarm) could be browsed and modified as well.
1.
Meter Para.
Type: MT50
Ver: Hardware + Software
SN: XXXXXXXXXX
Note: When the set up is accomplished, the auto switch page cannot become effective
until ten minutes later.
14
Notes
Voltage compensation: Voltage control charging (default)
By setting the charge and discharge SOC target values for battery charge
and discharge control
No
2.
Sw-Pages: XXS
BKLight: XXS
AudiAlarm: on/off
Meter Para.
Advertisement
Table of Contents
