Chapter 3 No-Picture Problem - Eizo RadiForce GX560 Instructions For Use Manual

Chapter 3 No-Picture Problem

Problem
1. No picture
• Power switch indicator does not light up
• Power switch indicator lights up: Green
• Power switch indicator lights up: Orange
• Power switch indicator blinks: Orange,
Green
2. The message below appears.
• This message appears when no signal is
input.
Example:
• The message indicates that the input signal
is out of the specified frequency range.
Example:
Possible cause and remedy
• Check whether the power cord is connected properly.
• Turn the main power switch on.
• Touch .
• Turn off the main power, and then turn it on again.
• Try increasing the "Brightness" and "Contrast" ("4-Text"
mode only) values in the setting menu. For details, refer to
the Installation Manual (on the CD-ROM).
• Turn off the main power, and then turn it on again.
• Switch the input signal. For details, refer to the Installation
Manual (on the CD-ROM).
• Move the mouse or press any key on the keyboard.
• Check whether the PC is turned on.
• If the Presence Sensor is set to "On", the monitor may be in
power saving mode. Try moving closer to the monitor.
• Check whether the signal cable is properly connected.
Connect to
when selecting "DisplayPort1", and to
selecting "DisplayPort2" in the input signal. Use
when using a daisy-chain connection.
• Turn off the main power, and then turn it on again.
• Connect via the signal cable specified by EIZO. Turn off the
main power, and then turn it on again.
• When connected to DisplayPort1, try switching the
DisplayPort version. For details, refer to the Installation
Manual (on the CD-ROM).
These messages are displayed when the signal is not input
properly even if the monitor is functioning properly.
• The message shown left may appear, because some PCs do
not output the signal immediately after power-on.
• Check whether the PC is turned on.
• Check whether the signal cable is connected properly.
• Switch the input signal. For details, refer to the Installation
Manual (on the CD-ROM).
• Check whether the signal cable is properly connected.
Connect to when selecting "DisplayPort1", and to
selecting "DisplayPort2" in the input signal. Use
when using a daisy-chain connection.
• Turn off the main power, and then turn it on again.
• Check whether the PC is configured to meet the resolution
and vertical scan frequency requirements of the monitor (see
"4-2. Compatible Resolutions" (page 21)).
• Reboot the PC.
• Select an appropriate setting using the graphics board's
utility. For more information, refer to the User's Manual of the
graphics board.
for output
for output
Chapter 3 No-Picture Problem
when
when
19