Physical Installation - Nautilus NH-1800 Operator's Manual

NH-1800

4.3 Physical Installation

To install the NH-1800 ATM, perform the following steps.
Place the " Anchor bolts locate sheet " at the place where the machine is to be installed.
1)
(refer to Fig. 4.5)
Place the system on a flat surface, the system has a tendency to tip over if the surface is
2)
over 10 degrees. (refer to Fig 4.6) Be careful when opening the top or bottom of the
machine s it will be off balance
Place the Anchor nuts into the ground according to the anchor bolts locate sheet.
3)
(4 places)
Place the NH-1800 on top of the sheet.
4)
Open the Security cover with the key provided.
5)
Using the supplied combination (factory preset at 50-25-50) open the Security Door.
6)
This combination should be changed as soon as possible. Refer to Appendix B for
instructions on changing the lock combination.
After the anchor nuts are in place according to the anchor holes on the bottom of the
7)
NH-1800, tighten the anchor bolts tightly. (refer to Fig. 4.7)
Fig. 4.5
4-5
4. Installation