Nautilus NH-1800 Operator's Manual page 164

NH-1800
A0803
AXXX3
AXXX4
AXXX5
AXXX6
AXXX7
AXXX8
Receipt Paper Jam
Receipt paper jam
A jam error occurred while the receipt
printer operates.
Receipt paper is empty.
It was detected that paper was empty
while the receipt printer was operating
(when the paper empty sensor detected
the light).
"Receipt paper setting error
Jam and miss-feeding are detected during
receipt paper is loaded. -> This error
occurs when the setting sensor detects a
dark part.
During the test in the offline mode of the
Slip Printer
Feed Lever Opened
Receipt paper cutting error.
Receipt paper cutting failed.
Printer board.
1. Remove jammed paper
1. Remove paper jam and paper scraps.
2. Check the lever operatio position in
the sensor.
3. Check if the sensor is polluted.
4. Check if cable is cut or the connector
is wrongly inserted.
5. Check logic related to jam detection
in the Slip Printer board.
1. Set receipt paper.
2. Check the lever operation position in
the sensor.
3. Check if cable is cut or the connector
is wrongly inserted.
4. Check logic related to the paper
empty sensorin the Slip Printer board.
1. Remove paper jam and reload.
2. Check the level oepration position in
the jam sensor.
3. Check if cable is cut or the connector
is wrongly inserted (in the jam sensor).
4. Check logic related to the jam sensor.
5. Check if the return motor is operating.
6. Check if cable is cut or a connector is
wrongly inserted in the return motor, and
check related logic.
Turn off/on Slip Printer.
Check feed lever and sensor pollution
1. Remove paper jam.
2. Check if the cutter properly rotates
and the swtich normally functions.
3. Check if cable is cut or the connector
is wrongly inserted.
4. Check logic rlated to the cutter of the
Slip Printer board.
7 - 16
7. Appendix