Regency CV72EPV-NG Owners & Installation Manual page 64

CITY SERIES
installation
12. Bend the arm of the aeration lever bracket up from 90° to straighten and
release aeration lever (lever will come with the burner).
Bracket
Aeration
lever
13. Loosen 8 screws in locations shown below (2 at front and 2 at rear)—slide
burner to the left away from the orifi ce and lift out.
14. Remove burner orifi ce with a 3/8" wrench. Use another wrench to hold
on to the elbow behind the orifi ce. Discard orifi ce. Reinstall new burner
orifi ce LPG stamped #47 and tighten.
15. Remove pilot retainer clip with pliers and pull off the pilot cap to expose
the pilot orifi ce.
Pilot retainer clip
| City Series CV72EPV
64
919-821
Burner screw locations
Slide burner to the left and lift out
Burner Orifi ce
Location
16. Unscrew the pilot orifi ce with the Allen key; then replace with the LPG
pilot orifi ce and the pilot cap, provided in the kit.
17. Reinstall pilot cap and pilot retainer clip.
18. Prior to installing burner—adjust aerations settings - to 3/8" for LP. Re-
install burner (see Step 11).
19. Ensure the pilot light is in the correct orientation to the Burner. Recon-
nect the gas and electrical supply to the appliance. Start the appliance.
(see section on Lighting Instructions) Ensure that pilot and burner igni-
tion is completed without delay. Check both your inlet and outlet pres-
sures at full load. With a soapy solution, leak test the entire system.
Verify both the correct fl ame and pilot appearance.
20. See Gas Pipe Pressure Testing in manual.
Min. Supply Pressure
Manifold Pressure - High
Manifold Pressure - Low
Orifi ce Size
Maximum Input
Minimum Input
Altitude
Installer Notice:
These instructions must be left
with the appliance
2
City Series
NG SYSTEM DATA
11" WC (2.73kpa)
10" WC (2.49 kpa)
6.4" WC (1.59 kpa)
#47 DMS
45,500 Btu/h (13.33 kW)
36,000 Btu/h (10.55 kW)
0-4500 ft (0-1372m)
.
08.24.17