Regency CV72EPV-NG Owners & Installation Manual page 53

CV72EPV
10. Remove front faceplate from Power Vent unit by removing 4 screws
as shown below.
11. Loosen 4 screws in locations shown below, lift rain guard off screws
(key hole slots).
12. Inside the Power Vent box--connect the blue and red wires to the
pressure switch as shown below.
Red Wire
Blue Wire
13. Bundle the wires together with the supplied grommet and pop the
grommet with wires into the bracket on the roof of the Power Vent box.
Grommet in bracket
919-851
14. Install the second grommet onto the wires and secure grommet and
wires into a bracket located on the side of the Power Vent box
Grommet in bracket
15. Connect ground wire to ground lug located at back of Power Vent box.
16. Connect wires from pressure switch to wires from BX cable--Red
to Red and Blue to Blue. Cap paired wires with supplied marrette.
17. Connect remaining wires from powervent motor to BX cable- Black
to Black and Black to White. Cap paired wires with supplied marrette.
NOTE: After exposure to heat--White wire will appear Yellow -- Blue wires
will appear Green.
18. Reinstall rain guard and tighten screws.
19. Reinstall front faceplate with 4 screws.
Note: This power vent cap can be serviced externally or internally. If ac-
cess to the exterior is not possible once installed due to height/location of
the termination location, it is highly recommended that an access panel
be placed near the rear of the termination inside of the enclosure where
the power vent cap is located. The access panel should be large/close
enough to be able to service the power vent cap. See maintenance sec-
tion of manual to see how servicing is completed internally.
4
installation
Ground
Red to Red
Black to White
Black to Black
City Series CV72EPV |
05.31.18
53