Russound SIX-SOURCE CONTROLLER CAM6.6 Instruction Manual Page 60

Six-zone, six-source controller; six-zone, six-source am/fm receiver.
Hide thumbs

Advertisement

INSTALLER
INSTALLATION MENU
c. Selected: Default
(Deflt)
d. Selected: Macro:
(Macro)
i. MACRO -
(Macro)
ii. MACRO ID –
(MacID)
e. All Other Selections:
4. DEVICE CODE –
(DevCd)
5. KEY FUNCTION –
(KeyFn)
6. POWER OFF CMD –
(OfCmd)
7. COMMAND TYPE –
(CmdTp)
a. Selected: Learned IR
(LrnIR)
i. LEARNED SRC –
(LnSrc)
b. Selected: Unassigned
(Unasg)
c. Selected: Default
(Deflt)
d. Selected: Macro:
(Macro)
i. MACRO –
(Macro)
ii. MACRO ID –
(MacID)
60
Default selects the same device type and device code previously
setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 5)
(To build macros, see Macro Editor page 62)
Macro loads a series of commands which are processed when
activated.
Enter the macro ID number. Menu advances to POWER OFF CMD
(step 6)
Procedure advances to DEVICE CODE (step 4)
Source component code for IR control.
Select a function (Play, Enter, etc.).
Tells the controller to turn off the selected source equipment (by
SOURCE NUMBER) when the last of the UNO System Keypads is
turned off. If "no," procedure advances to SAVE CHANGES (step 10)
Select the type of source command (e.g., CD, TV, etc.).
Choose Learned IR if the pre-programmed IR code library does
not support the source component.
Select the learned source bank to be assigned to the source
component. Procedure advances to KEY FUNCTION (step 9)
The Power Off command is cleared. Procedure advances to
SAVE CHANGES (step 10)
Default selects the same device type and device code previously
setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 9)
(To build macros, see Macro Editor page 62)
Macro loads a series of commands which are processed when
activated.
Enter the macro ID number.Menu advances to SAVE CHANGES
(step 10)
(continued next page)

Advertisement

   Also See for Russound SIX-SOURCE CONTROLLER CAM6.6

   Related Manuals for Russound SIX-SOURCE CONTROLLER CAM6.6

This manual also for:

Cam6.6t

Comments to this Manuals

Symbols: 0
Latest comments: