2. COMMAND TYPE –
(CmdTp)
a. Selected: Learned IR
(LrnIR)
i. LEARNED SRC –
(LnSrc)
b. Selected: Unassigned
(Unasg)
c. Selected: Default
(Deflt)
d. Selected: Macro:
(Macro)
i. MACRO -
(Macro)
ii. MACRO ID –
(MacID)
e. All Other Selections:
3. DEVICE CODE –
(DevCd)
4. KEY FUNCTION –
(KeyFn)
5. SAVE CHANGES? –
(Save?)
# OF SOURCES (#Srcs)
At this field it is necessary to enter the number of sources used in the CAM6.6 system (1 to 6). This
limits the sources displayed on the keypad in the normal running mode when the source button is
pressed, but also limits source selections in the configuration menus. See Source Select
Command & # Of Sources - Flow Chart on page 70
Select the type of source command (e.g., CD, TV, etc.).
Choose Learned IR if the pre-programmed IR code library does
not support the source component.
Select the learned source bank to be assigned to the source
component. Procedure advances to KEY FUNCTION (step 4)
The source select command is cleared. Procedure advances to
SAVE CHANGES (step 5)
Default selects the same device type and device code previously
setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 4)
(To build macros, see Macro Editor page 62)
Macro loads a series of commands which are processed when
activated.
Enter the macro ID number. Menu advances to SAVE CHANGES
(step 5)
Procedure advances to DEVICE CODE (step 3)
Source component code for IR control.
Select a function (Play, Enter, etc.).
Select "yes" to save the changes.
INSTALLER
INSTALLATION MENU
57