INTERNAL SOURCE - AM/FM TUNER
UNO-S2 Keypad Control
UNO-S2 Keypad Control of Tuner
Selecting the tuner
On the UNO-S2 keypad, press
AM/FM tuner by choosing the tuner's preas-
signed source number (1).
Selecting the desired band
to toggle between AM band and FM
Selecting the desired frequency
for manual tuning. The fre-
quency will appear on the keypad and the active
tuner. To move quickly through the stations,
press and hold either
A press on
will seek the next higher tune-
able station. If a tuneable station is not found,
end the SEEK function by pressing
To scan, press and hold then release
tuner scans through tuned stations with a 5-sec-
ond preview before moving to the next station.
To end scanning, press
Selecting a Bank
The AM/FM tuner can store up to 36 favorites,
or memory presets. These are stored in groups
to select the
for more than
of six called banks, and there are six banks.
Each preset and each bank can be given a cus-
tom name of your choice.
To select a bank, press and hold
for bank down. The bank's name will
be temporarily displayed on the UNO-S2. Banks
and memory presets are custom-named in the
Peripheral Setup Menu (see Installation Menu
section of this manual).
Setting a Memory Preset
The SRC2 remote control is used to set memory
presets for all six banks. See page 22 for
Recalling a Memory Preset
to scroll through the memo-
ry presets for the selected bank. This procedure
will step through all of the presets in the current
bank, then loop back to start at the first one.
Only configured presets will be displayed.
to mute/unmute the tuner audio output.