Russound SIX-SOURCE CONTROLLER CAM6.6 Instruction Manual: Peripheral Setup

Six-zone, six-source controller; six-zone, six-source am/fm receiver.
Hide thumbs

Advertisement

The following items make up the Installation Menu:
PERIPH SETUP (PerSu)
CTRLR SETUP (CtlSu)
MACRO EDITOR (MacEd)
PERIPH SETUP (PerSu)
Note: For CAM6.6, Peripheral Setup is not applicable. "N N o o t t A A v v a a i i l l " shows on the keypad.
Peripheral Setup allows the CAM6.6's optional internal source to be configured.
The following items can be found in the PERIPH SETUP menu:
MEM NAME (MemNm)
FACTORY INIT (FInit)
MEM NAME (MemNm)
NOTE: A memory preset must be created and saved before it can be named. Once it is saved, the
preset's Tuner #, Bank # and Memory # must be entered in the following procedure.
This procedure accesses a name entry field to enter a custom name for a memory preset. See
Periph Setup - Flow Chart on page 64
1. BANK # –
(Bank#)
2. MEMORY # –
(Mem #)
3. MEMORY NAME –
(MemNm)
BANK NAME (BnkNm)
This procedure accesses a name entry field to enter a custom name for each of the tuner's six
banks. See Periph Setup - Flow Chart on page 64
1. BANK # –
(Bank#)
SOURCE SETUP (SrcSu)
POWER MGT (PwMgt)
SYSTEM INFO (SInfo)
BANK NAME (BnkNm)
SYSTEM INFO (SInfo)
Select the BANK # of the memory preset.
Select the MEMORY # of the preset to be named.
Use the volume up/down keys to select a character and left/right
keys to change a character position. A blinking cursor indicates
placement of the character being entered. Names can be from 1
to 5 characters in length. If adding names from 6-12 characters,
it is suggested you use an optional UNO-S2 keypad.
Select the BANK # of the memory preset.
INSTALLATION MENU
ZONE SETUP (ZonSu)
LEARN IR (LrnIR)
CONTROLLR ID (CtlId)
INSTALLER
REGION (Rgion)
(continued)
49

Advertisement

   Also See for Russound SIX-SOURCE CONTROLLER CAM6.6

   Related Manuals for Russound SIX-SOURCE CONTROLLER CAM6.6

   Related Content for Russound SIX-SOURCE CONTROLLER CAM6.6

This manual also for:

Cam6.6t

Comments to this Manuals

Symbols: 0
Latest comments: