Controller Setup - Russound CAV6.6-S2 Instruction Manual

INSTALLER
INSTALLATION MENU
Zone Setup (cont'd)
5. PAGE ENABLE -
(PagEn)
6. PAGE VOLUME -
(PagVl)
CTRLR SETUP (CtlId)
Controller Setup is the basic configuration of the controller. This setup menu selects the options for
Controller ID and Factory Initialization. See Installation Menu on Page 55 and Controller Setup -
Flow Chart on page 73
1. CONTROLLER ID -
(CtlId)
2. FACTORY INIT -
(FInit)
POWER MGT (PwMgt)
The CAV6.6 is capable of managing the power state of the connected source equipment. The power
management is configured on a source-by-source basis.
All sources that have power management enabled are initialized by a "POWER ON" command or
macro which must cause the source to produce an audio signal. Power management is initialized
when the first keypad is turned on or when the home theater trigger input has 12VDC present. The
12VDC trigger output is turned on when the first zone is turned on.
All sources that have power management enabled are turned off by the "POWER OFF" command after
all zones have been turned off, with a timeout of five minutes.The 12VDC trigger output is turned off
62
This feature is either disabled or enabled. It allows the option of
receiving or blocking a page in a zone. If disabled, the page will
not be sent to the zone. If enabled (default), the page will be
sent to the zone.
This feature allows the installer to adjust the Page Volume for the
zone, from 0 (min) to 100 (max).
This defines the Controller ID for this system. The default is 1 but
when multiple controllers are used, each additional controller ID
must be sequential and unique and be set before being connect-
ed to the system. Note that the system must be restarted before
the controller will assume the new ID.
WARNING: This procedure returns the controller to its
original settings - use with discretion.
Factory Initialization allows the installer to erase all programmed
settings and returns the settings to the factory default settings.
All settings including source equipment IR commands will need to
be reentered. An "Are you sure?" prompt and a "no" response
allows the installer to cancel the reset; a "yes" at the prompt will
load factory/default settings.