Programming Center Keypad Port Connection - Russound CAV6.6-S2 Instruction Manual

Programming Center Keypad Port Connection

The CAV6.6 can be programmed via keypad
connection using CAT-5 and the T568A RJ-45
wire configuration. An UNO-S2 Keypad can be
attached to the controller at the Programming
Center Keypad Port Connection.
The Programming Center Keypad Port is
designed for use in local programming, specifi-
MAKING CONNECTIONS
cally for learning IR commands directly into the
IR receiver on the controller's front panel. (see
Learn IR flow chart on page 75).
The CAV6.6 can also be programmed from any
UNO-S2 keypad connected to its keypad ports.
INSTALLER
43