Source Setup; Basic Setup - Russound CAV6.6-S2 Instruction Manual

The following items make up the Installation Menu:
SOURCE SETUP (SrcSu)
POWER MGT (PwMgt)
SYSTEM INFO (SInfo)
SOURCE SETUP (SrcSu)
Source Setup allows the system's sources to be configured.
The following items can be found in the SOURCE SETUP menu:
BASIC SETUP (BasSu)
SRC VOL TRIM (SrcVT)
# OF SOURCES (#Srcs)
BASIC SETUP (BasSu)
NOTE: The BASIC SETUP procedure should be performed for each source before proceeding to other
source setting changes.
This procedure uses built-in source "templates" to quickly and easily configure the source settings
needed for basic operation of the source component. Before performing BASIC SETUP, connect the
source components to the CAV 6.6 as outlined in the Source Connections section. Also be sure that
all sources are powered on. See Basic Setup - Flow Chart on page 67
1. SOURCE NUM –
(Src #)
2. SOURCE NAME –
(Name)
3. COMMAND TYPE –
(CmdTp)
a. Selected: Learned IR
(LrnIR)
i. LEARNED SRC –
(LnSrc)
ZONE SETUP (ZonSu)
LEARN IR (LrnIR)
KEY CONFIG (KeyCf)
NUMERIC IR (NumIR)
Select the source to be configured.
Select the name for the source (e.g., DVD, Aux 2, Jazz, etc.).
Select the type of command template (e.g., CD, TV, etc.). Selecting
the command type template will tell the CAV 6.6 how to configure the
key's command and text for the source component.
Choose Learned IR if the pre-programmed IR code library does
not support the source component.
Select the learned source bank to be assigned to the source
component. (See Learning IR procedure for instructions on how
to learn IR codes.)
INSTALLATION MENU
CTRLR SETUP (CtlSu)
MACRO EDITOR (MacEd)
SOURCE NAMES (SrcNm)
SRC SEL CMD (SrcSC)
INSTALLER
55