Basic Operation - MAJORITY Abbey BT Instruction Manual

Instructions Guide

Basic Operation

Please note all (Ref.)refer to the Controls and Functions mapping
guide on Pages 1-2.
Plug the power supply plug into the mains, and the connector
into the back of the system via the DC input (Ref.13).
Alternatively, power by using 4 x AA batteries in the battery
compartment (Ref.17).
Ensure that the radio is turned on by the ON/OFF switch at the
back of the radio (Ref.12)
Fully extend the antenna (Ref.15) so that the best signal can be
received.
Press the 'Standby/Mode' button (Ref.1) to turn the radio on and
move from the standby screen. The radio should then go straight
to DAB radio mode and automatically start scanning for stations.
The display will show "Searching" and can take a few minutes to
scan.
If the radio does not automatically scan, you will need to go to
DAB mode and press the Scan button (Ref.3) to initiate this.
Press the 'Standby/Mode' button (Ref.1) to switch between DAB,
FM and Bluetooth modes.
Standby
To put the radio back into standby, press and hold the 'Standby/
Mode' button (Ref.1). To turn completely off, turn the switch at
the rear of the unit to OFF and switch off at the mains.
6