Default Settings; Setting Display Language - YOKOGAWA ROTAMASS Total Insight General Instruction Manual

General Instruction Manual
System configuration and operation
The following values are only available for the trend display to record data on the mi-
croSD card. Additional information about data recording can be found in the applicable
software instruction manual.
Only use the microSD card included with the Rotamass Total Insight. Functionality of the
device cannot be guaranteed if other cards are used.
Tab. 2: Trend display
Abbreviation
MFL
DNS
TMP
VFL
PRS
CNC
NM1
NV1
PHS
FRQ
DRG
DRC
MBT
VSC

9.3 Default settings

9.3.1 Setting display language

1. Press [SET] switch for 2 seconds to enter [Operation level].
2. Press [▼] switch 1 time to enter [Operator].
3. Press [SET] switch to enter [Device setup].
4. Press [▼] switch until [Lang] is selected.
5. Press [SET] switch to enter the [Lang] menu.
6. Press [▼] switch repeatedly until the desired language appears.
7. Press [SET] switch to select the desired language.
8. Press [SET] switch to confirm the language selected.
72 / 90
Measured quantity or identification
Mass flow
Density
Temperature
Volume flow
Pressure
Concentration
Net mass flow rate 1
Net volume flow rate 1
Phase shift
Resonance frequency
Drive gain
Driving current
Transmitter temperature
Viscosity
ð Display switches to the next higher menu level.
IM 01U10B00-00EN-R, 3rd edition, 2018-07-09
Default settings