Upgrading Software - Digital Networks DECserver ConX4 Installation And User Manual

Step Action
3 Connect to console terminal of DECserver. (Factory Default: Port 1, Baud=9600,
Parity=None, Databits=8, and StopBits=1) If your configuration settings have changed
you console settings may be different.)
4 Apply power to the DECserver.
5 During the boot sequence of the DECserver initialization process, press Ctrl/B two times
consecutively.
6 If you are using a BOOTP/TFTP or MOP to load your file at the ">>>" prompt type:
If you are using a TFTP server as your load host, you must provide TFTP load
information using the S command. This procedure is outlined below:
Specify the IP address for the DECserver to use:
Specify the IP address of the TFTP Server:
Specify your IP Gateway:
Now boot the firmware update image:
7 Wait for the module to reset or reset manually after bootrom update success message is
displayed.

Upgrading Software

For information on upgrading your DECserver Network Access software please refer to Network Access
Server Install Guide.
2-14 Installation
>>> b/u filename
>>> s ip=###.###.###.###
>>> s tftp=###.###.###.###
>>> s gw=###.###.###.###
>>> b/u filename