Table of Contents
Advertisement
On-Board Flash Memory
Step
6
7
Upgrading Software
For information on upgrading your DECserver Network Access software please refer
to Network Access Server Install Guide.
2-18 Installation
Action
If you are using a BOOTP/TFTP or MOP to load your file at the
">>>" prompt type:
>>> b/u filename
If you are using a TFTP server as your load host, you must
provide TFTP load information using the S command. This
procedure is outlined below:
Specify the IP address for the 90M+ to use:
>>> s ip=###.###.###.###
Specify the IP address of the TFTP Server:
>>> s tftp=###.###.###.###
Specify your IP Gateway:
>>> s gw=###.###.###.###
Now boot the firmware update image:
>>> b/u filename
Wait for the module to reset or reset manually after bootrom
update success message is displayed.
Advertisement
Table of Contents
Need help?
Do you have a question about the DECserver 90M+ and is the answer not in the manual?
Questions and answers