Table of Contents
Advertisement
Contact your Digital Networks sales representative for information on approved PSE devices.
Configuration Installation
Depending on your configuration, you can install the DECserver ConX
or it can be mounted in a standard 19-inch rack (see note at the bottom of this page).
Tabletop Installation
•
Attach the included rubber feet to the bottom of the unit.
•
Connect the 10/100Base-T connector to a properly configured 10/100BASE-T
network as shown in Figure 2–2.
•
Chose your power option: Standard AC or PoE. Figure 2-2 shows Standard AC
configuration.
•
Verify that the power LED is on and that the DECserver ConX
self-tests.
•
Verify that the DECserver ConX
Wallmount Installation
•
The wall mounting cover plate (refer to Figure 2–4) is available as an option.
•
Use the mounting plate as a template and position each of the #8 1-inch mounting
screws (not supplied).
•
Secure the mounting screws.
•
Replace the mounting cover plate on the unit.
•
Connect the 10/100Base-T connector to a properly configured 10/100BASE-T
network as shown in Figure 2–2.
•
Chose your power option: Standard AC or PoE. Figure 2-3 shows Standard AC
configuration.
•
Verify that the power LED is on and that the DECserver ConX
self-tests.
•
Verify that the DECserver ConX
Figure 2-3 shows the standalone configuration of the 10/100BASE-T connection as described in Table
2-1.
4
as a tabletop device, on a wall,
4
successfully ran all of the self-tests.
4
successfully ran all of the self-tests.
4
is running the
4
is running the
Installation 2-3
Advertisement
Table of Contents
Need help?
Do you have a question about the DECserver ConX4 and is the answer not in the manual?
Questions and answers