Your Comand Equipment; Important Safety Notes; Vehicle Settings - Mercedes-Benz COMAND Operating Instructions Manual

Vehicle settings

62

Your COMAND equipment

These operating instructions describe all
i
the standard and optional equipment of
your COMAND system, as available at the
time of going to print. Country-specific dif-
ferences are possible. Bear in mind that
your vehicle may not feature all functions
described here. This also applies to safety-
relevant systems and functions.
Read the information on qualified special-
i
ist workshops in the vehicle Operator's
Manual.

Important safety notes

G
WARNING
If you operate mobile communication equip-
ment while driving, you will be distracted from
traffic conditions. You could also lose control
of the vehicle. There is a risk of an accident.
Only operate this equipment when the vehicle
is stationary.
You must observe the legal requirements for
the country in which you are currently driving
when operating mobile communications
equipment in the vehicle.
Vehicle settings
Calling up vehicle settings
Press the Ø button.
X
or
Vehicle
Press in the main function bar.
X
The vehicle menu is displayed.
Vehicle Settings: turn and
To select
X
press the controller.
The menu for the vehicle settings is active.
To select the desired vehicle setting: turn
X
and press the controller.
The main area with the setting element is
active.
Selecting a different vehicle setting:
To activate the menu for selecting the vehi-
X
cle setting: slide 5 the controller.
Exiting the vehicle settings:
To select &: slide 6 and press the con-
X
troller.
Ambient lighting
General notes
You can set the following for the ambient
lighting:
Zone
R
The zone setting determines the area in
which the brightness setting is to be
applied. If the Complete zone is selected
for longer than 0.5 seconds, the brightness
of the Front zone is adopted for the entire
vehicle.
Brightness
R
This setting makes an additional change to
the brightness of the ambient lighting. The
brightness change is only effective for the
selected zone. For this reason, the zone for
which the brightness change is to be active
must be selected first.
Color
R
This setting changes the color of the ambi-
ent lighting.