Real-Time Traffic Report - Mercedes-Benz COMAND Operating Instructions Manual

Displaying reports on the route
The function is only available while route guid-
ance is active. It shows the available traffic
reports affecting the current route.
If there are no reports for the route or the
function is not supported in the selected lan-
Messages On Route
guage: the
gray and cannot be selected.
To switch to navigation mode: press the
X
Ø button.
To show the menu: slide 6 the control-
X
ler.
To select Traffic: turn and press the con-
X
troller.
Messages On
To select
X
press the controller.
The traffic report window appears. Several
traffic reports may be available for the cal-
culated route, marked for example by 1/3.
The report shows the following information:
State/province, road and display of the
R
affected direction
Section of the road to which the traffic
R
report applies
Traffic icon and traffic report
R
To display the next/previous traffic
X
report: turn the controller.
To close the display: press the % but-
X
ton.
Displaying all traffic reports
To switch to navigation mode: press the
X
Ø button.
To show the menu: slide 6 the control-
X
ler.
To select Traffic: turn and press the con-
X
menu item is
troller.
To select
X
the controller.
A list is shown containing all roads, areas or
regions affected by traffic reports. Roads,
areas or regions not on the route also
appear in the list.
To select the road, area or region: turn
X
Route: turn and
the controller and press to confirm.
The traffic report is displayed. There may be
several traffic reports for the affected road.
You can find an example of a traffic report
here: (
To close the display: press the % but-
X
ton.
Settings for the display on the map
You can switch these displays on/off on the
map:
Incidents
R
Speed & Flow
R
Free Flow
R
To switch to navigation mode: press the
X
Ø button.
To show the menu: slide 6 the control-
X
ler.
Real-time traffic reports
All Messages: turn and press
page 119).
Y
119
Z