Omron NT631 Operation Manuals page 61

Using a Memory Unit (NT631/NT631C with V1)
Reading and Writing Data by Manual Transmission
Reference
52
In this method, the direction of transmission and area of the memory unit used are
set by touch switch operations at the NT631/NT631C. Transmission can be exe-
cuted while checking the settings.
When data is written to the NT631/NT631C or memory unit, the data that has been
stored up until that point is lost.
S Method of execution
Use the following procedure to write screen data using manual transmission.
(1) Check that the NT631/NT631C power is OFF, then set the DIP switches on
the memory unit as follows.
SW1
Setting of SW1-4 not relevant
In order to avoid loss of data in the event of misoperation, it is advisable to
set SW2-1 and SW2-2 so as to disable writing to the unit from which the data
is to be read.
(2) Switch the NT631/NT631C power ON.
Display language select screen appears.
(3) Press the "Japanese" or "English" touch switches to select the display lan-
guage.
The following descriptions are for when "English" is selected.
The screen shown below is displayed.
SW2
Setting of SW2-4 not relevant
Setting of SW2-3 not relevant
Section 3-5