Omron NT631 Operation Manuals page 488

Display and Control of Windows
Opening a Window by Pressing a Touch Switch That Has the "Window Moving" Function
[Setting]
[Operation]
Reference
Opening/Closing/Moving a Window by the Operation of Window Control Area
[Setting]
In this method, a window can be moved by operation at the NT631/NT631C.
By this method, only the local window can be controlled.
When creating a screen using the Support Tool, set the "window moving" function
for a touch switch and register it for the window to be moved.
(1) Press the touch switch which has the "window moving" function on the win-
dow to be moved.
The window is changed to a frame display only with a "+" mark at the center of
it.
(2) Press the touch panel of NT631/NT631C at a destination position of the win-
dow.
Window is moved to that position. (The center position of the window comes
to the pressed position. )
If the window is going to extend out the screen boundary with the specified
position, the position of the window is automatically adjusted so that the win-
dow comes within the screen.
Window move touch switch
Move
When a window control area is allocated to a host, the bottom left coordinate of the
window after moving operation is notified to the window control area. (Refer to
page 484)
If this method is used, the window can be opened, closed and moved by operation
from the host.
By this method, both the global window and local window can be controlled.
To use a window control area, allocate the window control area to a word in the host
when creating a screen using the Support Tool.
Press the destination position
Section 8-4
Move
481