GE 850 Instruction Manual page 142

SOFTWARE INTERFACE
NOTE:
NOTE
3–48
Figure 3-23: Control Object Symbols
GE symbols are color-coded ANSI symbols.
The control objects status follows the color scheme from the
Panel > Display Properties > Color Scheme
(open)". If set to "Red (open)", the status colors are reversed.
If the setting is used, the breaker symbols automatically change to the Truck CB symbols.
The SLD assumes that if the Breaker Racked-In/Racked-Out input is used (any setting other
than "Off"), the appropriate Truck CB symbol will be used.
The following figure shows the orientation available for the control objects. The default
position for the control objects is 0 degrees. Orientation in multiple directions allows for
configuration of the single line diagram according to the existing drawings and ensure the
correct side for the fixed/moving contacts.
Setpoints > Device > Front
setting. By default, this setting is set to "Green
850 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 3: INTERFACES