Quick Setup; Set The Time And Date; Program Store Address - ISHIDA Astra II Bench Operation Manuals

1.5

Quick Setup

1.5.1

Set the Time and Date

Use the following steps to set the time and date.
1. Remove the Speed Key Insert page if in use over the keys.
2. Enter then press
4000
3. Press the
Down Arrow
4. Press . C01-01 DATE displays along with current set date.
Enter
5. Enter the date in a MMDDYYYY format.
Example: For June 21, 2015, enter 06212015.
6. Press twice. C01-02 TIME displays along with current set time.
Enter
7. Enter the time in a HHMMSS format.
Example: For 1:10:00 pm, enter 131000 (time is entered in 24 hour format).
8. Press twice. C01-04 JULIAN DATE displays.
Enter
9. Press 1801-0000 ENT OR CLR displays.
Mode.
10. Press . C01 DATE TIME displays.
Enter
11. Press twice to exit Adjustment Mode. Scale is ready to resume operation.
Mode
1.5.2

Program Store Address

Use the following steps to enter store information.
1. Remove the Speed Key Insert page if in use over the keys.
2. Enter then press
9000
3. Press then press
6
4. Press . P06-00 no.XXXX displays.
Enter
5. Enter Store Number then press
If store information has been programmed, it will display. If necessary, store information may be edited by pressing
Note
Edit. To delete any existing text, press Line Delete.
6. Press . INP 0001-0000 00 displays.
Enter
7. Type the store name then press
8. Press . P06-00 NO. XXXX displays.
Enter
9. Press then press
2
10. Press . INP 0001-0000 00 displays.
Edit
11. Type the store address then press
Note See Section 5.2 on page 28
12. Press . P06-00 NO. XXXX displays.
Enter
13. Press then press
4
14. Enter Store Number used in step 5. Press
15. Press three times to exit the Program Mode. Scale is ready to resume operation.
Mode
. < C00 ADJUST > displays.
Mode
. C01 DATE TIME displays.
. < P00 PROGRAM > displays.
Mode
. P06 STORE displays.
Enter
. 13001-0000 ENT OR CLR displays.
PLU
. 19001-0000 ENT OR CLR displays.
Enter
. P06-02 ADDRESS displays.
Enter
. 19001-0000 ENT OR CLR displays.
Enter
for text editing information.
P06-04 PRINTER1 displays.
Enter.
Enter
twice to assign programmed store. P06-00 NO. XXXX displays.
© Rice Lake Weighing Systems ● All Rights Reserved
Introduction
5