Table of Contents
Advertisement
Show Me Cables
The Extron Show Me cables are for use with Extron TeamWork systems. They feature a Share button for remote input source
selection and a control pigtail, which may be wired directly into Extron switchers with contact closure and tally outputs.
HDMI Show Me cable
VGA Show Me cable
Display Port
Show Me cable
Mini Display Port
Show Me cable
Connecting Show Me Cables
Connect the input end of the Show Me cable to the source device.
1.
Connect the HDMI output to the Extron switcher.
2.
Extron MPS 601 Switcher
MPS 601
1
POWER
12V
RGBHV
0.5 A MAX
2
SHOW ME CABLE
SWITCHER END
(output)
Male VGA connector
Connect the black (Tally Out) and red (Contact In) pigtail wires as shown above. The number adjacent to the Tally Out and
3.
Contact pins must correspond to the video input on the switcher.
Press the
button to switch the connected source to the main presentation display. Pressing the
4.
Share
a momentary contact closure, which triggers the switcher to select the connected source device. If a tally output is available,
the button lights blue.
NOTES:
•
The drain wire does not need to be wired to the switcher. The Show Me cables are grounded via the video
connectors.
•
Do not connect the Show Me cable to the +V pin on the Extron switcher.
•
The source device provides the +5 VDC supply voltage needed to illuminate the
does not supply this +5 VDC, the
voltage to light up the button.
•
Digital Show Me cables support embedded audio and CEC signals.
INPUT
(to source device)
Top of Cable Cubby
INPUT
(to source device)
Top of Cable Cubby
INPUT
(to source device)
Top of Cable Cubby
INPUT
(to source device)
Top of Cable Cubby
INPUTS
OUTPUT
A
3
5
HDMI
4
6
HDMI
HDMI
B
Three-conductor
pigtail for contact
closure and tally
Male HDMI connector
button will not illuminate. Some mobile devices do not provide the required
Share
Three-conductor
Share Button
pigtail for contact
closure and tally
Three-conductor
Share Button
pigtail for contact
closure and tally
Three-conductor
Share Button
pigtail for contact
closure and tally
Three-conductor
Share Button
pigtail for contact
closure and tally
C
G
T
C G
T
C G
T
+V
1
3
5
CONTACT IN / TALLY OUT
REMOTE
RS-232
2
4
6
C
G
T
C G
T
C G
T
Tx Rx G
C
G
T
C G
T
1
3
CONTACT IN / TALLY OUT
2
4
C
G
T
C G
T
Red
(C)
Drain wire
Black
(not used)
(T)
Pigtail
(to switcher)
Bottom of
Cable Cubby
(to switcher)
Bottom of
Cable Cubby
C G
T
5
6
C G
T
button creates
Share
button. If the source device
Share
OUTPUT
OUTPUT
OUTPUT
(to switcher)
Bottom of
Cable Cubby
OUTPUT
(to switcher)
Bottom of
Cable Cubby
7
Advertisement
Table of Contents
