MSA Ultima X Instruction Manual page 3

General Warnings and Cautions
1. The Ultima X Sampling Module - Aspirated Model described in this
manual must be installed, operated, and maintained in strict
accordance with the labels, cautions, warnings, instructions, and
within the limitations stated.
2. The Ultima X Sampling Module - Aspirated Model is designed to
sample gases or vapors in air. It cannot sample the concentration
of gases or vapors in steam or condensing streams or inert or
oxygen deficient atmospheres.
3. The unit must not be painted. If painting in an area where this unit
is located, ensure that paint is not deposited on the module inlet
fitting. Such paint deposits interfere with the sampling process and
can result in improper readings.
4. Sensors are sealed units containing a corrosive electrolyte. Should
a sensor develop leakage, immediately remove it from service;
then, remove it from its housing assembly and discard it properly.
Ensure that the electrolyte does not contact skin, eyes, clothing or
circuitry; otherwise, personal injury (burns) and/ or equipment
damage may result.
5. Use only genuine MSA replacement parts when performing any
maintenance procedures provided in this manual. Failure to do so
may seriously impair instrument performance. Repair or alteration
of the Ultima X Sampling Module - Aspirated Model, beyond the
scope of these maintenance instructions or by anyone other than
an authorized MSA service person, could cause the product to fail
to perform as designed, and persons who rely on this product for
their safety could sustain severe personal injury or death.
6. Properly vent the exhaust of this unit to a safe area. Improper
venting of the exhaust can cause personal injury or death.
ii
" WARNING