Goulds Pumps 3700 Installation, Operation And Maintenance Manual page 43

7. Place the end plate over the driver shaft and locate the end plate in the annular groove at
the rear of the coupling guard half.
1. Annular groove
2. End plate
8. Repeat steps 3 through 5 for the rear end of the coupling guard half, except that you hand
tighten the nut.
9. Slide the rear coupling guard half towards the motor so that it completely covers the shafts
and coupling.
1. Driver
2. Slide to fit
10. Repeat steps 3 through 5 for the center slots in the coupling guard.
11. Firmly tighten all nuts on the guard assembly.
Install the coupling guard with the optional air cooling package
1. Is the deflector-fan guard support installed?
Model 3700, API Type OH2 / ISO 13709 1st and 2nd Ed. / API 610 8/9/10/11th Ed. Installation, Operation, and Maintenance
Manual
• If yes: Make any necessary coupling adjustments and then proceed to step 2.
• If no: Complete the following steps:
Commissioning, Startup, Operation, and Shutdown
41