Audible Signal - AEMC 5100 User Manual

Megohmmeter Models 5000N/5100/5110

Audible Signal

When the push-to-test button is in the ON or LOCK-IN position, an
audible signal will result. This signal consists of approximately one beep
every six seconds (ten beeps per minute). The signal can be used as a
time base for monitoring the duration of the test. On the MΩ and GΩ
ranges, the signal indicates that the instrument is in operation and that
the selected DC test voltage may be present on the terminals of the
instrument.
Note: On the Models 5100 and 5110, the audible signal may be
disconnected by means of a jumper located on the main circuit board.
Connector to
battery board
ON
OFF
Figure 11
- 26 -