Error And Maintenance Messages - Brother DCP-T310 Reference Manual

Error and Maintenance Messages

The most common error and maintenance messages are shown in the table. For more detailed
information, see the Online User's Guide.
You can correct most errors and perform routine maintenance yourself. If you need more tips, go
to your model's FAQs & Troubleshooting page on the Brother Solutions Center at
support.brother.com.
Error Message
B&W Print Only
Refill [X]
Cannot Print
Refill [X]
Change Paper?
Close ink cover.
Data Remaining
Disconnected
Document Jam
Action
The amount of remaining ink in one or more of the ink tanks (except
black) is low.
Refill the ink tank.
For more detailed information, see the Online User's Guide: Refill the
Ink Tanks.
The machine may stop all print operations and you may not be able to
use the machine until you refill the ink tank in the following cases:
• If you unplug the machine.
• If you select the Slow Drying Paper option on the machine or in
the printer driver.
The amount of remaining ink in one or more of the ink tanks is low.
The machine will stop all print operations.
Refill the ink tank.
For more detailed information, see the Online User's Guide: Refill the
Ink Tanks.
• You can still scan even if the ink is low or needs to be refilled.
This message is displayed when the setting to confirm the paper type
and size is enabled.
To not display this confirmation message, change the setting to Off.
For more detailed information, see the Online User's Guide: Change
the Check Paper Size Setting.
The ink tank cover is not locked in the closed position.
Firmly close the ink tank cover until it locks into place.
Press Stop/Exit. The machine will cancel the job and clear it from the
memory. Try to print again.
Try to send or receive again.
If calls are stopped repeatedly and you are using a VoIP (Voice over
IP) system, try changing the Compatibility to Basic (for VoIP).
See Related Information: Telephone Line Interference/VoIP at the end
of this section.
The document was not inserted or fed correctly, or the document
scanned from the ADF was too long.
For more detailed information, see the Online User's Guide: Document
Jams.
19