Adding Another Device To An Existing Wireless Alarm Network - Quell Q4000DCS-WCB User Manual

F. WIreless setUP comPlete!
If all devices flash green and "Sonar" ping has stopped, the devices are now connected. Congratulations!
g. PleAse select locAtIon And InstAll AlArm
Please see section 8 "Installation / Mounting Instructions"
7.2 Adding Another Wireless Device to an Existing
Wireless Alarm Network
For various reasons, you might want to add additional units to your existing
wireless alarm network. Modifying your existing wireless alarm network is easy
and user-friendly.
A. remoVe the neW deVIce From Its PAcKAgIng.
b. PoWer UP neW deVIce
Locate the red wheel on the back of the device being added. Turn the red
wheel to the "ON" position using the white activation tool included in the
Quick Start Guide or a standard screwdriver.
•
Once powered, the light ring will glow red.
c. PIcK one InstAlled deVIce
Press and hold the button on ONE INSTALLED device on your network until
you hear two beeps. Release button. You will hear "Searching for other
devices."
•
Light will pulse green and device will sound a continuous "Sonar" ping
until step E is completed.
d. relAX And WAIt
Wait until the new device has connected to the network. Once connected,
the new device will speak, "Success now connected!"
•
Once connected, the light ring will glow green.
e. FInIsh AddIng neW deVIce - comPlete WIreless
netWorK setUP
Press and hold the button on the INSTALLED device for 5 SECONDS until you
hear two beeps. Release button. "Sonar" ping will stop.
•
Device will announce that setup is complete and the number of
connected devices.
USE ACTIVATION
TOOL OR SCREWDRIVER
Figure 7.2-B
"Searching for
other devices."
Device Being Added
Installed Device
Figure 7.2-C
"Success, now
connected!"
Figure 7.2-D
"Setup
complete!"
Installed Device Added Device
Figure 7.2-E
12