Power Supply Connection; Mounting The Repeater; D Using The Supplied Handles; Fuse Replacement - Icom IC-FR6000-L Instruction Manual

n Power supply connection
Make sure the repeater's power is turned OFF when
connecting a DC power cable.
R WARNING! NEVER apply more than 16 V DC to
the DC power receptacle on the repeater rear panel.
This could cause a fire or damage the repeater.
n Fuse replacement
If a fuse blows, or the repeater stops functioning, find
the source of the problem, repair it and then replace
the damaged fuse with a new rated one.

D Line fuse replacement

n Mounting the repeater

D Using the supplied handles

The supplied handles are used when mounting the re-
peater into a 19 inch rack. The handles are installed on
the repeater's front panel.
q Attach the supplied handles to both sides of the re-
w The completed installation should look like the illus-
Fuse rating: 20 A
USE only a 20 A fuse.
INSTALLATION AND CONNECTIONS
peater's front panel with the spacers, then tighten
the screws as shown below.
P 0
Handle
tration below.
CAUTION: DO NOT replace the fuse with the DC
power cable connected to the repeater. Disconnect
the cable to prevent electric shock and/or equip-
ment damage.
Fuse rating: 1 A
USE only a 1 A fuse.
2
P 1
P 2
P 3
P 4
Screw
Spacer
P 0
P 1
P 2
P 3
P 4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
6