Ir Led Module - HP Elite x2 1013 G3 Maintenance And Service Manual

IR LED module

Description
IR LED module
IMPORTANT:
Before removing the module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Display panel (see
b. Disconnect the battery cable (see
c. Remove the camera connector bracket (see
Remove the IR LED module:
CAUTION:
Disconnect the camera cable from the reverse ZIF connector (1) and then use a tool to pry the camera
▲
module up to disengage the adhesive that secures it to the computer (2).
Reverse this procedure to replace the IR LED module.
50 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Make special note of each screw size and location during removal and replacement.
Display panel on page
Use care to prevent damaging the zero-insertion force (ZIF) connector and ribbon cable.
33)
Battery on page 36)
Camera connector bracket on page
Spare part number
L31350-001
44)