Water-Drainage - ElectrIQ P12C User Manual

WATER-DRAINAGE

MANUAL DRAINAGE:
1. When the internal water tank is full the unit will stop working and display the message "E2" on
the display.
2. Shut off the unit and unplug. Try not to move the model abruptly as this may cause water to spill
out from internal water tank.
3. Place a tray under the water plug.
4. Screw off the water plug and unplug the water blocker - water will drain from the container.
5. Put the water blocker back and screw the water plug back into place
CONTINUOUS DRAINAGE:
1. Screw off the water plug and unplug the water blocker.
2. Use a water pipe to connect to the water outlet.
3. You can plumb this pipe into your current plumbing system,
lead it outside or use a water pump.
Note: This model has a self-evaporative function, which reduces the need to empty the water tank. If
the unit is vented correctly most of the water is reused to cool the condenser coils and any excess is
evaporated. Please do not use continuous drainage if you intend to use the self-evaporating facility.
In heating or dehumidifier mode you may need to use the permanent drainage.
Page 13 of 18