Gree GRS-CQ8.0Pd/NaEK Service Manual page 63

4. When above settings are finished, pressing the Return key and then pressing "Save", a pop-up
window will pop up to remind if you are determined to save these settings. If so, press the OK key
If not, press the Return key
5. In this case, finally by pressing the Up key
[Notes]
① Totally five periods are allowed to be set for each time. For each period, "Start time" must be
earlier than "End time". Similarly, the preceding period must be earlier than its following period.
② When "Weekly timer" has been set successfully, by changing "FCU" , "Ctrl. state", or "T-water
ctrl.", then the temperature set point for "Weekly timer" will be automatically changed to the set
point of last setting. For instance, if "Heat" is set for Monday of "Weekly timer", "FCU" is set to
"With" and the "T-water out" is 20°C, by resetting "FCU" to "Without", then "T-water out" will
be the value of last setting. In this case, if FCU is disabled for last setting, then "T-water out"
will be the default value (18°C).
③ At the "WEEKLY TIMER" setting page there are totally three setting types for each day
"√" : it indicates once the Week Timer is activated, the timer on this day is effective and will
not be affected by the "Holiday" mode.
"×": it indicates even if the Week Timer is activated, the timer on this day is ineffective.
"Holiday Mode": it indicates when the Week Timer is activated but "Holiday Mode" is not
activated, then the timer on this day is effective; when "Holiday" is also activated, the timer on
this day is ineffective.
④ When "Weekly timer" has already been set and the concerned modes include "Hot water", if
Unit Control
to not save these settings.
, "Weekly timer" will be activated.
58
.