Gree GRS-CQ8.0Pd/NaEK Service Manual page 54

2. At the FUNCTION page, by the Right/Left key
selected, and by the Up/Down key
The function key no. 3
by pressing the Menu key
key the control will back to the higher level menu.
[Notes]
① Move the cursor to the desired option and "Enter" will be displayed at the lower left side of the
LCD, reminding you that you are allowed to access to the submenu by pressing the OK key
.
② At the FUNCTION page, when the setting of some function option is changed and needs to be
memorized, then in case of power failure it will be saved automatically and resume upon power
recovery.
No. Full Name
Running
1
mode setting
2 Control state
Fast hot
3
water
Water out
4 temperature
control
Unit Control
FUNCTION page 1
, the setting of the current function option can be modified.
or no. 4 can be used for switch pages. After the setting is finished,
, the control will back to the homepage, or by pressing the Return
Function Settings
Displayed Name
Mode Hot water
Cool+Hot water
Heat+Hot water
T-water out /
Ctrl. state
Fast hot water
High temp./
T-water ctrl.
Normal temp.
, the desired function option can be
Range Default
Cool
Heat
Heat
T-water
T-room out
On/Off Off
Normal
temp.
49
Remarks
When the water tank is unavailable,
then only "Cool" and "Heat" are
included in the range.
"T-Room" is available only when
"Remote Sensor" is set to "WITH".
When the water tank is unavailable,
this function will be reserved, and
the LCD will display 'Reserved'.
1. When "Floor config" is set to
"With", the function is defaulted to be
"Normal temp." and cannot be