JUKI LK-1910 Instruction Manual page 61

Error
Indication
code
E040 Sewing area over
The pattern size exceeds the sewing range.
E043 Enlargement error
The sewing pitch is beyond 10 mm.
E045 Pattern data error
The pattern data cannot be adopted.
E050 Temporary stop
Temporary stop by operating the reset key
while the sewing machine is running. (Refer
to memory switch No. 31.)
E061 Memory switch data error
Memory switch data is broken or revision is
old.
E063 Machine head identification error
The type of machine head and the type of
control box do not match.
Connection alert for the USB thumb
E204
drive which is used for sewing
Sewing has been carried out by 10 or more
times with the USB thumb drive inserted in
the USB port.
E220 Grease replenishing time information
Information as to the time of replenishing
the designated places with grease.
E221 Grease replenishing warning error
Sewing machine has stopped since the
time of replenishing the designated places
with grease has come.
E302 Head tilt error
Head tilt detection switch is turned OFF.
E303 Z phase detection error
Detection of the upper dead point of the
sewing machine cannot be performed.
Description of error
－
59
Corrective measure
Press the RESET key. Then,
check the pattern and the X/Y
scale.
Press the reset key and check
the pattern and X/Y scale rate.
Re-operation is enabled after
resetting.
Re-start or return-to-origin after
thread trimming by means of
the reset key (For the details,
refer to the item "6-4. How
to use the temporary stop"
p.38).
Re-operation is enabled after
resetting.
Turn the power OFF and con-
tact JUKI or your distributor.
Re-operation is enabled after
resetting.
Replenish the designated plac-
es with grease and set mem-
ory switch No. 245 to "0" with
the RESET key. Error can be
released with the RESET key
when immediate replenishing
with grease cannot be per-
formed during sewing opera-
tion.
Immediately perform replen-
ishing with grease and set
memory switch No. 245 to "0"
with the RESET key.
The sewing machine cannot be
operated with the head tilted.
Return the sewing machine
head to its proper position.
Turn OFF the power switch.
Check whether the pin of the
SDC board CN15 has come off
or has loosened.
－
Remarks
This error is
output when
max. sewing
area, 100 × 50
is over. Inter-
ference of the
work clamp foot
with needle is
not protected.