JUKI LK-1910 Instruction Manual page 54

No.
U036 Feed timing is selected
When stitches are not well-tightened, set the value in
"–" direction.
U037 State of work clamp foot after completion of sewing can be selected
: Work clamp foot goes up after moving at the sewing start
: Work clamp foot goes up immediately after the end of sewing.
: Work clamp foot goes up by pedal operation after moving
at the sewing start.
Execution of origin retrieval every time after completion of
U039
sewing can be performed. (Except cycle stitching)
: Without origin retrieval
: With origin retrieval
U040 Setting of origin retrieval in cycle stitching can be set
: Without origin retrieval
: Every time 1 pattern is completed
: Every time 1 cycle is completed
U041 State of work clamp foot when machine stopped by temporary
stop command can be selected
: Work clamp foot goes up.
: Work clamp foot goes up with work clamp foot switch.
: Lift of work clamp foot is prohibited.
U042 Needle bar stop position is set
: UP position
: Upper dead point
U046 Thread trimming can be prohibited
: Normal
U048 Route of origin return by means of clear key can be selected
: Straight line return
: Reverse return of pattern
U049 Bobbin winding speed can be set
Function
: Thread trimming prohibited
－
Setting range
−1 to 8
-
-
-
-
-
-
-
800 to 2000
－
52
State when
Remarks
delivered
5 Setting on excessive "–"
side may cause needle
breakage. Be careful
when sewing heavy-
weight material.
Needle bar rotates in
the reverse direction af-
ter the UP position stop
and stops when upper
dead point stop is set.
This function is used
when straight line
return from the midway
of pattern to the start of
sewing is not possible.
1600 Max. speed limitation
has priority.