JUKI LK-1910 Instruction Manual page 35

(2) Method of editing cycle data
C D
 ❷ ❸
3) Selecting the edit point
When you press ITEM SELECT key
displayed in reverse video. When you move the edit point forward until the last point is reached,
additional indication pictograph
When you press EDIT key
graph is displayed at the selected position to enable insertion of pattern data.
4) Change data of selected editing point
Press DATA CHANGE key
Pattern No. which has been registered is displayed and it is possible to select.
In addition, press RESET key
When RESET key
deleted.
Repeat steps 3) and 4) to perform editing data.
5) Cancelling insertion of pattern data
Insertion of the pattern data is cancelled and the mode is changed over to the input mode by pressing
RETURN key
❻ ❼
❾
❽
❻ , the edit point is changed and the current point is
is displayed.
❽ while selecting the edit point, the additional indication picto-
❼ and data of editing point can be changed.
❸ , and the pattern data of editing point can be deleted.
❸ is held pressed for one second, all the registered pattern data can be
❾ .
1) Set the mode to input mode
Under the input mode where SET READY
LED  goes out, entry of the cycle data is
enabled.
If the current mode is the sewing mode, press
READY key
mode to the input mode.
2) Set cycle data to editing status
When EDIT key
data editing display C appears on the screen.
The pattern No. D to be sewn is displayed in
reverse video.
In this state, it is possible to edit the data.
－ －
33
❷ to change over the
❽ is pressed, the cycle