I Starti Ng The Cleaning Cycle - Zodiac CyclonX Instructions For Installation And Use Manual

3.5 I Starti ng the cleaning cycle

To prevent risk of injury or property damage, be sure to adhere to the following:
• Bathing is prohibited when the appliance is in the pool.
• Do not use the appliance during shock chlorinati on.
• Do not leave the appliance unatt ended for an extended period.
• Do not use the appliance if the roller shutt er is closed.
• When the control box is powered up, the following symbols light up to indicate:
- The acti on in progress
- The cleaning selected (depending on model)
- Maintenance required
• The control box switches to standby aft er 10 minutes and the screen is switched off . Press any key to exit standby
mode. Standby mode does not stop the appliance if it is in a cleaning cycle.
3.5.1 Cleaning cycle selecti on (depending on model)
• A cleaning cycle is already confi gured by default: the symbols are on.
• The cleaning cycle can be selected at any ti me, before the appliance starts or while it is operati ng. The new cycle will
start immediately.
• The cleaner adapts its movement strategy depending on the choice in order to opti mise the coverage rate.
3.5.2 Launching the cleaning cycle
• Press
Tip to improve cleaning performance
At the start of the bathing season, launch several cleaning cycles in bott om only mode (aft er removing the
large debris with a net).
Regular use of the cleaner (without exceeding 3 cycles per week) means that your pool will always be clean
and the fi lter less clogged.
3.5.3 Adjusti ng the cleaning ti me (depending on model)
• You may reduce or increase the cleaning ti me at any ti me (+/- 0.5 H.
• Press the butt on:
9
Surface to clean
Bott om only
Bott om + sides + water line
- 0.5 H
Normal
Durée
+ 0.5 H
normale
durati on