I Starting A Cleaning Cycle - Zodiac WR000411 Installation And User Manual

2.5 I Starting a cleaning cycle

In order to avoid any risk of injury or material damage, follow the instructions below:
• Bathing is prohibited when the appliance is in the pool.
• Do not use the appliance during a shock chlorination. Wait until the chlorine level has reached the
recommended value before immersing the cleaner.
• If the pool is covered, use the "Floor only" cleaning mode.
To start the cleaning cycle:
• Wait until the cleaner is fully charged (
• Once charged, remove it from its charger station and take it to the pool.
• Choose the cleaning mode, see "2.5.1 Choice of cleaning mode".
• Start the cycle, see "2.5.2 Starting the cleaning cycle".
• Immerse the cleaner, see "2.5.3 Immersing the cleaner".
2.5.1 Choice of cleaning mode
The cleaning mode defines the surface to be cleaned and the duration of the cleaning cycle.
• Slide the cursor on the rear of the cleaner to the left:
- One notch to select the "Floor only" mode,
- A second notch to select the "Floor + walls + waterline" mode.
The indicator corresponding to the mode will light.
•
Additional modes are available via the application (Waterline mode, Smart mode), see "3.2 I Functions
available in the iAqualink™ app").
green) to start a cycle.
Surface to clean Cycle duration
Floor + walls +
waterline
Floor only
EN
2h30
1h30
12