Control Panel Overview - HTC 800 RXP User Manual

1.4 Control panel overview

4
2
0
I
1
WARNING: When you do not use the machine
turn the START KEY to 0 and turn the knob
RADIO ON/OFF to 0.
1. START KEY SWITCH
Start key to start/stop the machine's functions:
• 0: OFF
• I: Electric power ON
• II: Ignition ON
• S: Start the engine.
2. IGNITION - Standby indicator
The led bulb comes on when the the start key is in
position II.
3. RADIO ON/OFF
Turn the knob to I to start the radio signal to the
radio control unit.
4. COM ERROR - Communication error indicator
The led comes on if there is no connection between
the machine and the radio control unit.
5. RADIO ENABLED - Radio control indicator
The led comes on when the knob "Radio ON/OFF" is
turned to "ON".
6. EM-STOP - Emergency stop switch
If an emergency occurs, press the EM - stop to stop
the machine.
4 - Introduction
8
10
MENU
SET
II 0 1
S
3
5
9
450 630 810
RPM
6
7. THROTTLE
Use one of the methods that follows to adjust the
throttle of the engine.
• Turn the knob.
• Push the center button on the knob and pull the
knob rearward.
8. MENU BUTTON
Press the button to toggle between the settings in
the display.
9. DISPLAY
See the section "Display" for detailed information.
10. SET BUTTON
Press the button to adjust the selected menu item.
11. RPM GUIDE
A guide that shows the speed interval of the grinding
discs.
• Yellow: Idle. Below 1400 rpm.
• Red: The cluch slips. Do not operate the
machine between 1400 - 2000 rpm.
• Green: Correct rpm to use when operating the
machine. 2000 - 3600 rpm.
Note: Always attach the machine to a winch when you
transport the machine on a slanted surface.
11
7
888 - 001 -