Mitsubishi Electric AJ65BT-RPI-10A User Manual page 38

No. Name
Station number
3) setting switch
(Tens)
Station number
4) setting switch
(Units)
5) Lens surfaces Used to make optical communication.
6) Terminal block Used to connect the power supply cable and CC-Link dedicated cables.
Termination
7)
resistor switch
Module
8) mounting
screws
Mounting
9)
bracket
Display window
10) mounting
screws
POINT
The settings of the transmission speed setting switch and station number setting switches
are made valid when the module power is switched from OFF to ON. If any switch setting
has been changed with the module power ON, perform the above operation again.
Used to set the station number of the module.
Also used to set whether the monitor function is used or not. (Factory
setting: 0)
00 : Monitor function is not used
01 to 64 : Station number when monitor function is used
65 to 99 : Must not be set.
Used to set whether the built-in termination resistor (110) of the
module is used or not. (Factory setting: OFF)
ON : Used
OFF: Not used
Used to fix the module to the mounting bracket.
Mounting bracket
Used to mount the module.
Used to fix the display window to the module.
The display window is removed when switch setting is to be made.
Application
23