Setting The Cable Type; Setting Cable Length Measuring Unit - HT QUICKLAN6050N User Manual

5.1.3. Setting the cable type

1. Switch on the instrument by pressing the key.
2. Press and hold the SET/UNIT key for 3s. The screen in Fig. 3
the display.
3. Press the arrow keys
4. Press the SET/UNIT key. Parameter
selecting one of the 10 numeric configurations saved by the user according to the type
and possible calibration of cable length (see § 5.5.1).
5. Press the arrow key
6. Press the SET/UNIT key to go to the selection of cable type. Parameter
on the display.
7. Press the arrow key
(CAT5), CA6 (CAT6), AJII (RJ11), COA (COAX)
8. Press the SET/UNIT key to go to the selection of cable type with RJ45 connector.
Parameter StP
"
9. Press the arrow keys
cable) or UtP (unshielded UTP cable)
10. Press the TEST/

5.1.4. Setting cable length measuring unit

1. Press and hold the L/W key and switch on the instrument by pressing the
instrument shows the screen in Fig. 6
2. Press the arrow keys
flashing on the display.
3. Press the TEST/
or until you display the screen in Fig. 5 - left side
Fig. 5: Setting the cable type
or to select the value among the options 0 ÷ 9
or
flashes on the display.
"
or
key to save all settings and go back to main screen.
Fig. 6: Setting length measuring unit
or
key to save setting and go back to main screen.
0 flashes on the display. This parameter allows
" "
to select the cable type among the options: CA5
to select the possible options. StP (shielded STP
left side.
–
to select measuring unit
EN - 7
QUICKLAN 6050N
left side appears on
–
.
CA5 flashes
" "
key. The
Mt (meter) or Ft
" " " "
(foot)