HPE Apollo k6000 User Manual page 39

a. Make sure that the orientation of the release lever is correct for installation in bay 3.
b. Prepare the switch for installation. Make sure that the release lever is fully open.
c. Install the switch, close the release lever, and then tighten the captive screw.
CAUTION: The switch will slide smoothly into the slot and connect to the backplane. Forcing the
switch into the slot or into the connector will damage components.
3. To Install the switch in bay 4:
a. Make sure that the orientation of the release lever is correct for installation in bay 4.
b. Prepare the switch for installation. Make sure that the release lever is fully open.
c. Install the switch, close the release lever, and then tighten the captive screw.
Installing the chassis 39