Paragon 2000 Plus Turbo Manual Owner's Manual page 35

REPLACEMENT OF INJECTOR
1. Repeat operations 1-7 for removal of gas control.
2. Disconnect gas connection to injector.
3. Disconnect the gas pipe at the gas valve.
4. Remove the 2 screws securing the burner and lift burner away.
5. Carefully remove the silencer, located around the injector.
6. Remove the back nut securing the injector.
7. Replace injector
8. Re-assemble in reverse order.
9. Turn on the gas supply and check for soundness.
10. Restore electrical supply and recommission appliance.
REPLACEMENT OF OXY-PILOT ASSEMBLY
NOTE: If the pilot assembly is replaced it must be replaced with an identical unit from the same manufacturer and
replaced as a complete unit.
1. Repeat operations 1-7 for removal of gas control.
2. Disconnect the thermocouple from the gas valve.
3. Disconnect the gas connection from the pilot assembly.
4. Remove ignitor lead from pilot assembly.
5. Undo the 2 screws securing the oxy-pilot to the burner.
6. Re-assemble in the reverse order. Turn on the gas supply and check for soundness.
7. Restore electrical supply and recommission appliance.
REPLACEMENT OF SILENCER
NOTE: The silencer must not be modified and must be correctly aligned.
1. Repeat operations 1-2 for removal of gas control.
2. Remove the 2 screws securing the burner and lift burner away.
3. Clean, service or replace silencer as necessary.
4. Re-assemble in reverse order.
www.charltonandjenrick.co.uk 35 LT5052 (ISS 5)